Cost of production will be of interest to the ******* who essays to construct a flying machine. Assuming that the size decided upon is double that of the glider the material for the framework, timber, cloth, wire, etc., will cost a little more than double. This is because it must be heavier in proportion to the increased size of the framework, and heavy material brings a larger price than the lighter goods. If we allow $20 as the cost of the glider material it will be safe to put down the cost of that required for a real flying machine framework at $60, provided the owner builds it himself.
As regards the cost of motor and similar equipment it can only be said that this depends upon the selection made. There are some reliable aviation motors which may be had as low as $500, and there are others which cost as much as $2,000.
Services of Expert Necessary.
No matter what kind of a motor may be selected the services of an expert will be necessary in its proper installation unless the ******* has considerable genius in this line himself. As a general thing $25 should be a liberal allowance for this work. No matter how carefully the engine may be placed and connected it will be largely a matter of luck if it is installed in exactly the proper manner at the first attempt. The chances are that several alterations, prompted by the results of trials, will have to be made. If this is the case the expert's bill may readily run up to $50. If the ******* is competent to do this part of the work the entire item of $50 may, of course, be cut out.
As a general proposition a fairly satisfactory flying machine, one that will actually fly and carry the operator with it, may be constructed for $750, but it will lack the better qualities which mark the higher priced machines. This computation is made on the basis of $60 for material, $50 for services of expert, $600for motor, etc., and an allowance of $40 for extras.
No man who has the flying machine germ in his system will be long satisfied with his first moderate price machine, no matter how well it may work. It's the old story of the automobile "bug"over again. The man who starts in with a modest $1,000 automobile invariably progresses by easy stages to the $4,000 or $5,000class. The natural tendency is to want the biggest and best attainable within the financial reach of the owner.
It's exactly the same way with the flying machine convert. The more proficient he becomes in the manipulation of his car, the stronger becomes the desire to fly further and stay in the air longer than the rest of his brethren. This necessitates larger, more powerful, and more expensive machines as the work of the germ progresses.
Speed Affects Weight Capacity.
Don't overlook the fact that the greater speed you can attain the smaller will be the surface area you can get along with. If a machine with 500 square feet of sustaining surface, traveling at a speed of 40 miles an hour, will carry a weight of 1,200 pounds, we can cut the sustaining surface in half and get along with 250square feet, provided a speed of 60 miles an hour can be obtained. At 100 miles an hour only 80 square feet of surface area would be required. In both instances the weight sustaining capacity will remain the same as with the 500 square feet of surface area--1,200 pounds.
One of these days some mathematical genius will figure out this problem with exactitude and we will have a dependable table giving the maximum carrying capacity of various surface areas at various stated speeds, based on the dimensions of the advancing edges. At present it is largely a matter of guesswork so far as ****** accurate computation goes. Much depends upon the shape of the machine, and the amount of surface offering resistance to the wind, etc.
